Sound Anchors ADMID User Manual
Page 5
IMPORTANT!!!! HIGHLY RECOMEMDED
MAKE CERTAIN THAT ALL SPIKES AND SCREWS ARE INSTALLED
BEFORE FILLING BECAUSE THE FILLER WILL ESCAPE IF THEY ARE NOT
If you are going to be filling your stands this is the me to do it. You may use any loose material to fill your stands (sand, pea
gravel or ki y li er are commonly used). We like and have been ge ng the best results using medium grit silica or general pur-
pose construc on sand . This sand is available at some larger or hardware stores and most home improvement stores (Lowes ,
Home Depot ect.).
1. Place the stand in a posi on close to a where it will be used.
2. A er you have determined the final posi on for your stands you will need to level the system using in the spikes at the floor.
When everything is adjusted properly you must lock down the jam nuts.
3. Repeat steps one through 10 on your second stand.
4. Place four Bluedots on each of your stand pla orms. You may now place your speakers on your stands.
5. You may adjust the height and angle of your speakers any me by carefully loosening the 7/16-14 socket screw and sliding the
pla orm up or down in the stand. When doing this make certain that you do not loosen the pla orm too much.
ADJUSTMENT
BOLTS