Taylor-Wharton VJ Bulk Tank - Manual (Page 20)

MOVING THE TANK
Purge and warm tank prior to removal and shipping. The tank must not be shipped cold because
the internal supports are not designed to withstand the shipping loads when the tank is cold.
Before moving the tank, refer to Taylor-Wharton Cryogenics Customer Service Dept. Refer to
rigging information in "Installation" section when relocating the tank.
TROUBLE-REMEDY GUILD
TROUBLE POSSIBLE CAUSES REMEDY
1. Tank Pressure too low. a. Pressure Vessel Safety Valve leaking
b.
Piping leaks to atmosphere.
c.
Low liquid level.
d. Excessive
product withdrawal.
e.
Improper filling procedure
a. Thaw out valve or replace if
b.
Test and repair tank
c. Refill
tank.
d.
Install higher capacity Pressure
e.
Refer to filling instruction in
2. Excessive tank pressure. a. Extensive shutdown time.
b.
Low withdrawal rate.
c.
Malfunction of Pressure Building
d.
Malfunction of tank Pressure Gauge.
e.
Lack of refrigeration caused by low
f.
Malfunction of Back Pressure Valve.
a. No Remedy.
b. No
Remedy.
c.
Refer to Step 3, this section.
d.
Replace Pressure Gauge.
e. Refill
tank.
f.
Refer to Step 3, this section.
3. Malfunction of Back Pressure Valve. a. Improper valve set point.
b.
Dirt on valve seat or valve
a. Check valve set point reset if required;
b.
Disassemble, inspect, clean, and
4. Erratic or erroneous Liquid Level
Gauge readings. a. Leaking gauge lines.
b.
By-pass valve open.
c.
Contents Gauge needle stuck.
d. Contents
Gauge needle not zero
e.
Gauge line reversed.
f.
Contents Gauge damaged or faulty.
g.
Plugged gauge lines.
a. Test and repair leaks.
b.
Close by-pass valve.
c.
Tap Contents Gauge slightly. Inspect
d. Adjust
as required.
e. Connect
properly.
f.
Replace Contents Gauge.
g. Disconnect
lines at Contents Gauge
20