Tomei Powered 3.692 FINAL GEAR SET (R34) - Manual (Page 8)

1. INSTALLATION
FRONT SIDE ILLUSTRATION
REAR SIDE ILLUSTRATION
8
1. Remove the oil from the final drive.
2. Remove the carrier case, then mark the bearing caps
so you can tell which is the correct one for up and
left from right. A paint pen marker is useful for this.
※For the rear only.
Once the diff case has been removed, make sure that
the side bearings and adjustment shims are marked
and separated. Do not mix them.
Mark (Point)
Rear Side
Flank Side
8