5 advanced features – Crown Audio K Series User Manual

Page 13

Advertising
background image

page 13

K Series Power Amplifiers

Operation Manual

NOTE: For detailed information about these Crown
amplifier features, please consult the Crown Amplifier
Application Guide
, available on the Crown website at
www.crownaudio.com.

5.1 Protection Systems

Your Crown amplifier provides extensive protection systems,
including protection against shorted outputs, open circuits, DC,
mismatched loads, general overheating, high-frequency over-
loads and internal faults.

5.1.1 TLC

If the amplifier starts to overheat, the thermal level control system
will subtly and dynamically reduce the gain as needed. Trans-
former overheating (extremely unlikely) will result in a temporary
shutdown. When the amplifier has cooled to a safe temperature,
the transformer will automatically reset itself.

5.1.2 Out-of-band Filtering

An 8-Hz high-pass filter protects the amplifier and loads from
subsonic frequencies. A 30 kHz low-pass filter offers protection
from ultrasonic frequencies.

5.1.3 Inrush Limiting

The “soft-start” feature prevents the amplifier from drawing a
large inrush current when it is first turned on.

5.1.4 Fuse

A fuse is provided to protect the power supplies from excess cur-
rent. It is located on the back panel below the power cord.

K-Series amplifiers that are configured to use 100-120 VAC
power should use the following fuses:

K2: 20-amp fuse.
K1: 15-amp fuse.

K-Series amplifiers that are configured to use 200-250 VAC
should use the following fuses:

K2: 10-amp fuse.
K1: 8-amp fuse.

5.2 Advanced Features

•

BCA (Balanced Current Amplifier) technology allows high
levels of power output without all the associated heat found
in a conventional amplifier. This highly efficient design
works without using a cooling fan.

•

Accurate, uncolored sound with very low distortion.

•

High damping factor for tight, clean bass response.

•

Advanced design for energy conservation.

•

Versatile, handling a wide range of speaker impedances and
outputs.

•

Switchable input sensitivity.

•

“Soft Start” feature prevents the amplifier from drawing large
currents when it is first turned on.

•

Can be mounted in standard 19-inch (48.3-cm) rack.
Uniquely molded, cast-aluminum front panel provides
exceptional air circulation.

•

Advanced protection circuitry guards against shorted out-
puts, open circuits, DC, mismatched loads, general over-
heating, high-frequency overloads and internal faults.

•

Mono mode switches allow you to set up your amps/speak-
ers in the configuration that best suits your needs, with
combined amp inputs, combined amp outputs, or both.

•

Backed by the industry’s ONLY three-year, no-fault, fully
transferable warranty.

5 Advanced Features

Advertising