Trail Tech X2 KIT: DUAL SPORT HALOGEN YAMAHA 37T2C-70 - Manual (Page 2)

010-ELV-98
DUAL-SPORT X2
Tech Support: 360-687-4530
[email protected] DUAL-SPORT X2
FEATURES AND WIRING
CABLE GUIDE:
CABLE GUIDE:
To install, thread the cables through the cable guide, then
screw the cable guide to X2 as shown to the right.
Be sure the cables are routed properly. The forks compress
during riding; the cables need enough room to move up and
down without causing damage.
MX bikes should use longer Enduro brake lines for optimum
X2 fitment. Example: CRF uses CRFX brake line, YZF uses
WRF line, etc.
STUB CONNECTOR:
WIRE COLOR
YELLOW
RED
BLACK
CONTROLS
4” SC4 BULB
2” MR16 BULB
GROUND
FUNCTION
HIGH BEAM
LOW BEAM
GROUND
CONNECT TO POWER:
Use the included wire stub connector to connect X2 to
power. The white connector allows for quick disconnect
and removal of X2 from the motorcycle. An on/off switch
is recommended. A fuse (10-20 amp) will protect from any
power spikes.
This stub connector is included in generic X2 kits.
Model-specific X2 kits contain switch-wire harness with
model-correct connectors to ease installation.
1. Turn the two screws shown below to adjust the beam.
1A. LOOSEN the two screws to LOWER the beam angle.
1B. TIGHTEN the two screws to RAISE the beam angle.
The two adjust screws are not required to be snug against
the back of X2.
ADJUST
SCREWS
ADJUST MR16 BEAM ANGLE: