Canon CP710 - Manual (Page 61)

59
Printing stopped midway.
The printer is not correctly
connected to the camera. z Connect the cable correctly (p. 31).
The printer’s power button lights red without the camera’s LCD monitor displaying
any error message.
There is a malfunction in the
printer.
z Remove the paper from the paper-handling slot and take
up any slack in the ink sheet. Turn the printer’s power off
and turn it on again.
Print quality is not good.
You are not using the correct
paper type. z Use the designated paper type.
Paper is loaded with the
wrong side up.
z Load the paper correctly (p. 28).
The ink sheet or paper is
dirty.
z Use a clean ink sheet and clean paper.
Condensation has formed
inside the printer.
z Wait for condensation to evaporate (p. 15).
Printed images are distorted.
The printer is too close to a
TV, video game machine, or
other electromagnetic
source. z Move the printer so that it is at least 1 meter (3.3 ft.) away
from the electromagnetic source.
The printer is too close to a
stereo speaker, large motor,
or other strong magnetic
source.
z Move the printer away from the strong magnetic source.
There is not enough ink left for the allotted sheets in the set.
You turned the printer’s
power on and off repeatedly.
z Please avoid turning the printer’s power on and off
needlessly.
You pulled on the ink sheet.
z Do not pull on the ink sheet by force.
You tore or bent the paper’s
perforated edges before
printing.
z Do not tear or bend the paper’s perforated edges.
You removed the ink
cassette when paper run out
while the printer was printing
more than one sheet of
paper.
z Load paper into the paper cassette without removing the
ink cassette.
Nothing happens when the camera’s , or SET button is pressed.
The printer has overheated. z Wait for the printer to cool down.
Printing is in progress. z Wait for the printer to finish printing.