Local management, 1 overview, Chapter 5 – Cabletron Systems 2208 User Manual
Page 45: Overview -1, Describes ho, Refer to, For information on how to, Er to, Chapter 5 local management
2H22-08R SmartSwitch 2208 User’s Guide
Page 5-1
CHAPTER 5
LOCAL MANAGEMENT
This chapter explains how to set up a management terminal to the
2H22-08R, and access the 2H22-08R using its Local Management
screens and commands.
5.1
OVERVIEW
Local Management is a series of management screens that allows you to
configure the 2H22-08R. The management screens allow you to do the
following tasks:
•
Assign IP addresses and subnet masks to the 2H22-08R
•
Assign a default gateway
•
Control access to the 2H22-08R by establishing Community Names
•
Download a new image of operating software
•
Designate which Network Management Workstations receive SNMP
traps from the 2H22-08R
•
View switch, interface, and RMON statistics
•
Assign ports to operate in Auto-Negotiate, standard or full duplex
mode
•
Perform load sharing by SmartTrunking ports
•
Configure optional Fast Ethernet Interface Modules of the 2H22-08R
•
Clear NVRAM, allows user-entered parameters such as an IP address
or Community Names to be deleted.
There are three ways to access Local Management:
•
Locally using a VT type terminal connected to the COM port of the
2H22-08R
•
Remotely using a VT type terminal connected through a modem
•
In-band through a Telnet connection