Chief Manufacturing CM6QH SERIES - Manual (Page 3)

Installation Instructions CM6QH SERIES
3
TOOLS REQUIRED FOR INSTALLATION
PARTS
System Features and Installation Requirements
Features
Remote Control Activated Lutron Light Dimmer Module
With this dimmer cabinet lighting can be switched on or off and dimmed using the left buttons on the hand held remote control
transmitter.
Obstruction Sensor
The system is equipped with a obstruction sensor. In the event that something would interfere the motion of the doors; the doors
stop, reverse, run a few seconds, and then stop again.
Auxiliary Controls
There is an activator button located on the front of the motor box which will activate the doors.
Status Light
The Status Light on the front of the Motor Box indicates the operating condition of the mechanism. In normal operating conditions,
the status light will be solid green with the doors at rest and will blink a series of green
twice, pause, green twice, pause ..., when the doors are in motion.
Installation Requirements
• 115VAC power at installation site
• Doors must be made of a non warping material.
7/16"
Li ghts Off
Scene 1 2
Bright Open
Door Ligh ts
Dim Close
(A) x1
(D) x1
(E) x1 (F) x2
(B) x1
(with motor)
(C) x1
(G) x2