Hookups, Selecting the best hookup option, Caution – Sony SLV-677HF User Manual
Page 7: Step 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
step 3
Hookups
Selecting the best hookup option
There are many ways in which your VCR can be hooked up. To hook up
your VCR so that it works best for you, first scan through the table below.
Then use the accompanying diagrams and procedures on the following
pages to set up your VCR.
If you have
Use
Refer to
TV that has audio/video input
Audio/video (A/V) hookup,
then
follow one of the hookups below.
Page 8
Antenna only, no cable TV
Hookup 1
Pages 9 and 10
Cable box with many scrambled
channels
Hookup 2
Pages 11 and 12
No cable box or cable box with only a
few scrambled charmels
Hookup 3
Pages 13 and 14
Cable box with only a few scrambled
channels, using an A / B switch
Hookup 4
Pages 15 and 16
After you've completed the connections, follow the instructions for setup.
During setup, if you need more details on the procedure described, page
numbers are provided where you can find complete, step-by-step
instructions.
After you've completed the setup, you're ready to use your VCR.
Procedures differ depending on the hookup you used. For an overview,
refer to "Quick reference to using the VCR" on the back cover.
Before you get started
• Turn off the power to all equipment.
• Do not connect the AC power cords until all of the cormections are
completed.
_ • Be sure you make connections firmly. Loose connections may cause
picture distortion.
• If your TV doesn't match any of the examples provided, see your nearest
Sony dealer or qualified technician.
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure to
do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the anterma terminals of your receiver.
Getting Started