Coleman 9992-647 - Manual (Page 14)

14
IMPORTANT!
T O ENSURE PROPER GAS FLOW , BURNER
CONTROL VALVES MUST BE “OFF” BEFORE
OPENING THE GAS CYLINDER VALVE
.
WARNING: During assembly
of the grill and when attaching or
replacing the L.P. gas cylinder,
insure that the gas supply hose is
free of kinks and/or damage and
is at least 3 inches away from hot
surfaces such as the grill casting.
Fig. 28
LP Cylinder Installation Fig. 27
1. Open the right door and slide out the cylinder support. Set the
LP cylinder in the cylinder support location with the outlet valve
facing toward the right side of the grill (Fig. 27).
Grill Assembly — 8400 Series
NOTE: Your 8400 Series grill is set up from the factory to use LP GAS. If you want to use NATURAL
GAS, you must purchase the NATURAL GAS CONVERSION KIT (sold separately). Please skip
to the section titled “Natural Gas Installation”.
Fig. 29 3. Slide the cylinder support back into the grill (Fig. 29).
2. Insert the TYPE 1 Nipple of the regulator into the cylinder’s fuel
valve outlet as shown (Fig. 28). Turn the regulator hand wheel
clockwise to tighten. No tools are needed. The hand wheel will
come to a complete stop when the connection is secure, and the
gas will not flow until a positive seal is achieved.