Clarion SA200 - Manual (Page 5)

SA200
5
I N S T A L L A T I O N G U I D E
P i c k - U p T r u c k I n s t a l l a t i o n
The antenna module should be mounted on the centerline of the roof approximately 4 inches from the rear
of the cab.
1. Follow Step 1-4 of Sedan Vehicle Installation.
· If the molding for the brake light is made out of rigid plastic, it might be necessary to drill a
small hole or slot to route the cable. Seal the hole with silicone compound after the installation.
2. Route the cable through the interior trim to where the receiver is located.
It is important that the coaxial cable is not damaged or kinked during the installation procedure.