Sony CCD-FX228 - Manual (Page 23)

Tips for Using the Supplied
Battery Pack
This section shows you how you can get the most out of
your battery pack.
Use up Before Recharging
• Be sure to use up the battery before you recharge it.
Qiarging a usable battery reduces battery capacity.
• If you finish recording before the indicator appears in
the viewfinder, turn the POWER switch to PLAYER, and
leave the camcorder on until the iX] indicator flashes
rapidly, for using up the battery.
• Battery capacity can be recovered if you fully
discharge and charge the battery again.
• Do not continuously recharge a charged battery pack.
This Vtfill cause the battery pack efficiency to
deteriorate.
Effective Usages for Less Discharge
Conserve Battery Power
Turn off the camcorder when you're not recording.
Keep in mind that when you turn STANDBY up and
position the subject, select an angle, or look through the
viewfinder, the battery is being used. The battery is also
being used when you insert or remove a tape.
Battery Life i$ Shorter in Cold Environments
Battery efficiency is decreased and the battery will be used
up more quickly when you record in a cold environment.
When to Replace the Battery Pack
When the tXi indicator in the viewfinder changes from
slow flashing to rapid flashing, the battery needs to be
charged.
Turn the POWER switch to OFF before replacing the
battery pack for smooth transition.
Note on the remaining battery indicator
The remaining battery indicator of the camcorder may indicate a
different remaining capacity from that of the battery pack with its
own indicator (not supplied). The indicator on the battery pack is
more accurate.
>
a
Q.
O
3
№
3
o
3
fit
r*
o'
3
23