On battery pack, On power failure, Troubleshooting – Sony SPP-SS950 User Manual

Page 15: Ni-cd

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Notes on power sources

On battery pack

• Store the battery pack at a temperature between 41 °F (5°C) and 95°F (35°C) for

best performance.

• If you do not use the cordless handset for a long period of time, remove the

battery pack, after charging for more than 12 hours.

On power failure

• During a power interruption, you cannot make or receive calls.

RECYCLING NICKEL-CADMIUM BATTERIES

NICKEL-CADMIUM BATTERY.
MUST BE DISPOSED OF PROPERLY.

Nickel-Cadmium batteries are recyclable. You can help preserve our
environment by returning your unwanted batteries to your nearest Sony

Ni-Cd

Service Center for collection, recycling or proper disposal.

Note:

In some areas the disposal of nickel-cadmium batteries in household

or business trash may be prohibited.

For the Sony Service Center nearest you call 1-800-222-SONY (United States only)

Caution:

Do not handle damaged or leaking nickel-cadmium batteries.

Troubleshooting

Symptom

Remedy

You cannot make or receive
calls.
You hear no dial tone.

•

Place the base unit away from noise sources.

• Move the handset closer to the base unit.
• Make sure you set up the base unit correctly.
• Make sure the battery is fully charged.

The phone does not connect at
all, even the number you dial is
correct.

• Make sure the dialing mode setting (pulse or tone) is

correct.

The phone doesn't redial
correctly.

• Make sure the last dialed number is really the one you

want to dial.

You hear five short error beeps
when you try to redial.

•

The number you last dialed exceeds 32 digits

(including the tone and pause digits if used).

•

The number you last dialed is erased.

You cannot store a speed dial
number.

• Make sure the number (including the tone and pause

digits) does not exceed 16 digits.

The handset does not ring.

• Set the RING ON/BATT SAVE switch to RING ON.

You hear interference during

conversation.

•

Move the handset closer to the base unit.

•

Place the base unit away from noise sources.

You hear a beep every second
during conversation.

• It is an out-of-range alarm. Move the handset closer to

the base unit within one minute.

You hear a beep every three
seconds and the TALK/BATT
LOW lamp flashes.

• The battery is’ weak. Charge the Battery for more than

12 hours.

Advertising