Using the built-in light, Replacing the bulb, Caution – Sony CCD-TR87 User Manual
Page 48: Note, Using the built-in light replacing the bulb
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using the built-in light
Replacing the bulb
Use the Sonv XB-3D halogen lamp (not supplied). The supplied halogen lamp is not on
the market. Purchase the Sony XB-3D halogen lamp.
Remove the power source before replacing the bulb.
(
1
)
While pushing the hole uncier the built-in light unit using a wire, remove the
unit.
(
2
)
Turn the bulb housing counterclockwise and detach from the built-in light
unit.
(3)
Replace the bulb using a dry cloth.
(4)
Attach the bulb housing turning it clockwise, then replace the built-in light
CAUTION
• When replacing the bulb, use only the Sony XB-3D halogen lamp (not supplied) to
reduce the risk of fire.
• To prevent possible burn hazard, disconnect the power source before replacing and
do not touch the bulb until the bulb becomes cool enough to handle (for about 30
minutes or more).
Note
To prevent the bulb from being smudged with finger prints, handle it with a dry cloth,
etc. If the bulb is smudged, wipe it completely.
50