Sony DCR-PC100 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Note

The processing lamp
lights while data is
transferred between
the "Memory Stick"
and the PC. While
transferring data, do
not remove the
"Memory Stick".
Doing so may
damage the data.

Make sure that the processing lamp goes off, and
press the eject button. The "Memory Stick" ejects.

Removing the "Memory Stick"

Press the eject button.

Precautions

• If the AC power adaptor or the serial cable is

disconnected while transferring data between the

"Memory Stick" and the PC or while displaying a
picture on the PC, data transfer will be stopped.
If the AC power adaptor becomes unplugged, exit the

PictureGear 3.2Lite software, remove the "Memory

Stick" and re-plug in the AC power adaptor. Then,
restart the software and perform the transferring
procedure.

If the serial cable is disconnected, exit the PictureGear
3.2Lite software, unplug the AC power adaptor, cormect
the serial cable firmly and then re-plug in the AC power
adaptor. After that, restart the software and perform the
transferring procedure again.

• If data transfer still carmot be performed successfully,

discormect and recormect the serial cable connector on
the MSAC-SRl or unplug and re-plug in the AC power
adaptor.

Advertising
This manual is related to the following products: