Warning, Precautions, Notes on the power lamp – Sony CCD-TR514 User Manual
Page 22: To remove the adaptor, Using the battery case, Ccd-tr99 only, Notes, Using alternative power sources
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using Alternative Power Sources
WARNING
AC power cord must only be changed at qualified service shop.
PRECAUTIONS
The set is not disconnected from the AC power source (mains) as long as it is connected to the wall
outlet, even if the set itself has been turned off.
Notes on the POWER lamp
•The POWER lamp will remain lit for a while even if the unit is unplugged after use. This is normal.
• If the POWER lamp does not light, disconnect the power cord. After about one minute, reconnect
the power cord.
To remove the adaptor
The adaptor is removed in the same way as the battery pack (p. 9).
Using the Battery Case
— CCD-TR99 only
Use the battery case (supplied) and six size AA (LR6) alkaline batteries (not supplied).
(
1
)
Remove the battery holder from the battery case.
(
2
)
Insert six new alkaline batteries into the battery holder, following the marking on the holder to be
sure the batteries are installed in the correct direction.
(3) Insert the battery holder with the alkaline batteries.
(4) Insert the battery case with the alkaline batteries to the battery mounting surface of the
camcorder in the same way as the battery pack (p. 9).
Battery Life
Using alkaline batteries at 77°F (25°C)
Model
Typical recording time
Continuous recording time
CCD-TR99
75 min.
135 min.
Notes
• The above battery lives are estimates. The battery life may be shorter depending on the storage
condition of the battery before being purchased and temperature.
• You may not use the battery case in clold environment.
22