Casablanca Fan Company Candelier Ceiling Fan C16G73T - Manual (Page 11)

11
C
ANDELIER
™
The POWER button is normally left in the on position. Always turn the power
off during cleaning or servicing the fan and during thunderstorms. It is also
used to exit or enter additional programs.
POWER must be left on to retain a previously set fan speed.
POWER
There are four individual speed settings for the fan; each speed is indicated by
an audible tone of increasing pitch.
To select the desired fan speed:
1. With fan off, press and hold the button labeled FAN. The fan blades will
start rotating at the slowest speed, and will increase in steps
2. Release the button when the desired speed is reached.
The fan speed is now in memory and will automatically come on at the same
speed each time the FAN button is used. To maintain this level of speed, turn the
fan on by pressing FAN less than one second. To lower speed, turn fan off, the
non by pressing and holding the FAN button until the desired speed is reached.
When the fan is on, you may increase the speed by pressing and holding the
FAN button until the desired speed is reached, then release it.
SPEED CONTROL
REVERSING AIRFLOW
The direction of airf low can be changed from
downward to upward or from upward to downward.
To reverse the airfl ow:
1. Make sure the FAN is on.
2. Press the REVERSE button.
FAN CONTROL
ON - OFF
A momentary press
of the FAN button
TO CHANGE SPEED
Press and hold FAN
button longer than
one second
NOTE: A four-toned signal indicates the command
was accepted by the fan. A few seconds later the fan
will slow to a stop and then reverse direction.
To turn the lights off and on, press and release the LIGHT button for less
than one second.
LIGHT
LIGHT CONTROL
ON - OFF
A momentary press of
the LIGHT button
R
R
R