Pass the refrigerator, Before, Installation – LG LSC 21943ST User Manual
Page 7: Warning, Disposal of the old appliance, Water supply installation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Pass the
refrigerator
Before
installation
Warning
Disposal of the
old appliance
Pass the refrigerator laterally through the access
door as shown in the right figure.
Mount the freezer and refrigerator
compartment doors
Mount them in the reverse sequence of removal after they pass through the access
door.
Water supply installation
Automatic icemaker operation needs water pressure of 21 ~121 psi (1.5-8.5
kgf/cm^) (That is, a paper cup (6 oz. or 180 cc) will be fully filled within
3 seconds.)
If water pressure does not reach the rating 21 psi (1.5 kgf/cm^) or below, it is
necessary to purchase a separate pressure pump for normal automatic icemaking
and cool water feed.
Keep the total length of the feed water pipe tube within 26' (8 m). Be careful for the
tube to avoid being kinked. If the tube is 26' (8 m) or longer it may cause trouble in
water feed.
Install the water supply line where it will not be affected by heat.
Connect to a potable water supply only.
This appliance contains fluids (refrigerant and lubricant) and is made of parts and
materials which are reusable and/or recyclable.
All the important materials should be sent to the collection center of waste material
and can be reused after rework (recycling). For recycling, please contact the local
recycling authority.