Craftsman 917.272230 User Manual
Page 30
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTING CHART
PROBLEM
CAUSE
CORRECTION
Will not start
1. Out of fuel.
1. Fill fuel tank.
2. Engine not “CHOKED"
2. See “TO START ENGINE"
properly.
in Operation section.
3. Engine flooded.
3. Wait several minutes
before attempting to start.
4. Bad spark plug.
4. Replace spark plug.
5. Dirty air filter.
5. Clean/replace air filter.
6. Dirty fuel filter.
6. Replace fuel filter.
7 Water in fuel.
7. Drain fuel tank and
carburetor, refill tank with
fresh gasoline and replace
fuel filter.
8. Loose or damaged wiring.
8. Check all wiring.
9. Carburetor out of adjustment.
9. See “To Adjust Carburetor"
in Service Adjustments
section.
10. Engine valves out of
10. Contact a Sears or other
adjustment.
qualified service center.
Hard to start
1. Dirty air filter.
1. Clean/replace air filter.
2. Bad spark plug.
2. Replace spark plug.
3. Weak or dead battery.
3. Recharge or replace
battery.
4. Dirty fuel filter.
4. Replace fuel filter.
5, Stale or dirty fuel.
5. Drain fuel tank and refill
with fresh gasoline.
6. Loose or damaged wiring.
6. Check all wiring.
7. Carburetor out of adjustment.
7. See “To Adjust Carburetor"
in Service Adjustments
section.
8. Engine valves out of
8. Contact a Sears or other
adjustment.
qualified service center..
Engine willnot
1. Clutch/brake pedal not
1, Depress clutch/brake
turn over
depressed.
pedal.
2, Attachment clutch is
2. Disengage attachment
engaged.
clutch.
3. Weak or dead battery.
3. Recharge or replace
battery.
4. Blown fuse.
4. Replace fuse.
5. Corroded battery tenninals.
5. Clean battery tenninals.
6. Loose or damaged wiring.
6. Check all wiring.
7. Faulty ignition switch.
7. Check/replace ignition
switch.
a. Faulty solenoid or starter.
8. Check/replace solenoid or
starter.
9. Faulty operator presence
9. Contact a Sears or other
swithch(es).
qualified service center.
Engine clicks but
1. Weak or dead battery.
1, Recharge or replace battery.
will not start
2, Corroded battery temninals.
2. Clean battery terminals.
3. Loose or damaged wiring.
3. Check all wiring.
4. Faulty solenoid or starter.
4. Check/replace solenoid or
starter.
30