Craftsman 152.213371 - Manual (Page 12)

Assemble U-Bracket (H) to Drum (J). Place a 5/16"
lock washer then a 5/16" flat washer onto a 5/16-
18 X 5/8" hex head screw (K) thru the hole in the
U-Bracket and the hole in the drum, thread a 5/16"
hex nut onto the hex head screw. Repeat this
process for the remaining hole and securely tighten
both screws. NOTE: U-Bracket should be mounted
to the right side of opening (L) in the drum as
shown. See figure 10.
Align the holes in the drum support with the holes in
the drum (M). Place a 5/16" lock washer on a 5/16-
18 X 5/8" hex head screw, then 5/16" flat washer
onto the hex head screw. Insert the hex head screw
thru the hole in drum support and drum. Thread a
5/16" hex nut onto the hex head screw and tighten
securely. See figure 11. Fasten the remaining
drum supports to the drum in the same manner.
Fig. 12
Fig. 11
7.
Place one end of 6-inch diameter flexible hose (N)
over blower/motor outlet(R). Slide one 6-inch
diameter hose clamp (S) down 6-inch flexible hose
and tighten hose clamp to blower/motor outlet.
See figure 12.
Place the other 6-inch hose clamp (T) over the
6-inch flexible hose. Attach the 6-inch flexible hose
to the drum inlet (U) and tighten 6-inch hose clamp.
See figure 12.
12