Craftsman 486.24504 - Manual (Page 12)

• Assemble the reduced ends of the R.H. support
tubes into the ends of the L.H. support tubes. Fasten
the tubes together using two 1/4" x 1" curved head
bolts, inserted from the top, and two 1/4" (SEMS) hex
nuts. See figure 11.
To install the fabric cart cover:
1. Unzip the cover's rear flap and place the cover on
top of the support tubes, making sure that the
zippered flap is at the rear of the cart.
2. Pull the front of the cover down over the front
support tubes and hook the cover's plastic channel
under the cart's front flange.
3. Pull the sides of the cover down and hook the
cover's plastic channel under the cart’s side
flanges.
4. Swing the rear flap up onto the top of the cover.
Starting at the top, secure the cover to the rear
support tubes with the three velcro straps on each
side. Tighten the straps so that the zipper is pulled
around behind the support tubes. The zipper
should close easily.
5. Unzip the rear flap to place the tailgate down into
the tailgate guides. See Figure 13.
Place the support tubes down into the front and rear
tube support brackets, with the tube's welded brack­
ets facing the center of the cart.
Assemble the top connecting tubes to the support
tubes using four 1/4" x 1-1/4" hex bolts and 1/4" hex
lock nuts.
Tighten only until there is no end play in
bolt. Tubing should fold up when removed from cart.
See Figure 12.
12