Craftsman 486.24276 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEP
10: (SEE FIGURE 10)
•
Raise the tractor's hood.
•
Insert the ends of the front brace rod into the inner set
of holes in the U-tube and rest the bottom of the brace
rod on the dash panel. If the brace rod is too long to
rest on the dash panel, you can shorten the overall
length of the rod by inserting the upper ends of the
rod into one of the wider spaced sets of holes.
STEP
11: (SEE FIGURE 11)
• With the tractor's hood still raised, place the snow cab
canopy onto the tubing frame and drape the front flap
down in front of the tractor's dash panel. Lower the
hood, trapping the front flap under the hood. Secure
the sides of the canopy by fastening the elastic hooks
to the bottom edge of the footrest and fender. Tie the
straps at back of canopy to the upright tubes. Any
levers or handles on snow throwers or snow blades
should be located outside of the cab.