Reposition right rear gauge wheel, Install mulcher plate (if previously removed), To convert to bagging or discharging – Craftsman 917.273631 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. Start the engine. After engine has
started, move throttle control to idle
position.
7. Depress clutch/brake pedal into full
"BRAKE" position and hold, yove
gearshift lever to 1st gear.
8. Slowly release clutch/brake pedal and
slowly drive tractor off skid,
9. Apply brake to stop tractor, set park
ing brake and place gearshift lever in
neutral position.
10. Turn ignition key to "STOP" position.
Continue with the instructions that follow.
REPOSITION RIGHT REAR GAUGE
WHEEL
For shipping purposes, the right rear
gauge wheel assembly is mounted upside
down on the mower. Remove the gauge
wheel assembly and reinstall from the
bottom as shown. To adjust gauge wheels,
see the Operation section in this manual.
INSTALL MULCHER PLATE
(If previously removed)
1
,
3.
Raise and hold deflector shield in
upright position.
Place front of mulcher plate over front
of mower deck opening and slide into
place, as shown.
Hook front latch into hole on front of
mower deck.
Hook rear latch into hole on back of
mower deck.
A
c
AUTION: D
o
not remove deflector
shield from mower.
TO CONVERT TO BAGGING OR
DISCHARGING
Simply remove mulcher plate and store in
a safe place. Your mower is now ready for
discharging or installation of optional grass
catcher accessory.
NOTE: It is not necessary to change
blades. The mulcher blades are designed
for discharging and bagging also.