To start engine with a weak battery – Craftsman 917.273840 User Manual

Page 26

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TO START ENGINE WITH A WEAK

BATTERY

i^WARNINO: Lead-acid batteries gen­
erate explosive gases. Keep sparks, flame
and smoking materials away from bat­
teries. Always wear eye protection when
around batteries.

If your battery is too weak to start the

engine, it should be recharged. (See "BAT­
TERY" in the MAINTENANCE section of
this manual).

If “jumper cables” are used for emergency

starting, follow this procedure:

IMPORTANT: Your tractor is equipped

with a 12 volt system. The other vehicle

must also be a 12 volt system. Do not use

your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES -

1. Connect one end of the RED cable

to the POSITIVE (+) terminal of each
battery(A-B), taking care not to short
against tractor chassis.

2. Connect one end of the BLACK cable

to the NEGATIVE (-) terminal (C) of
fully charged battery.

3. Connect the other end of the BLACK

cable (D) to good chassis ground,
away from fuel tank and battery.

TO REMOVE CABLES, REVERSE
ORDER -

1. BLACK cable first from chassis and

then from the fully charged battery.

2. RED cable last from both batteries.

REPLACING BATTERY

^WARNING: Do not short battery termi­

nals by allowing a wrench or any other object

to contact both terminals at the same time.

Before connecting battery, remove metal
bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected first to
prevent sparking from accidental grounding.

1. Lift hood to raised position.

2. Remove terminal guard.
3. Disconnect BLACK battery cable

then RED battery cable and carefully

remove battery from tractor.

4. Install new battery with terminals in

same position as old battery.

5. Reinstall terminal guard.
6. First connect RED battery cable to

positive (+) battery terminal with hex
bolt and keps nut as shown. Tighten

securely.

7. Connect BLACK grounding cable to

negative (-) battery terminal with re­
maining hex bolt and keps nut. Tighten

securely

8. Close terminal access doors.
9. Close hood.

Keps Nut

Terminal
Access ,

Door

Terminal
Guard

Positive
(Red) Cable

Negative (Black)

Cable

Weak or Dead
Battery

Fully Charged
Battery

26

Advertising