Craftsman 917.273823 - Manual (Page 30)

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEM CAUSE CORRECTION
Will not Start 1. Out of fuel.
2. Engine not “CHOKED”
properly.
3. Engine flooded.
4. Bad spark plug.
5. Dirty air filter.
6. Dirty fuel filter.
7. Water in fuel.
8. Loose or damaged wiring.
9. Carburetor out of adjustment.
10. Engine valves out of
adjustment.
1. Fll! fuel tank.
2. See “TO START ENGINE” in
Operation section.
3. Wait several minutes before
attempting to start.
4. Replace spark plug.
5. Clean/repiace air filter.
6. Replace fuel filter.
7. Empty fuel tank and carbure­
tor, refill tank with fresh gas­
oline and replace fuel filter.
8. Check all wiring.
9. See “To Adjust Carburetor”
In Service and Adjustments
section.
10. Contact a Sears or other
qualified service center.
Hard to start 1. Dirty air filter.
2. Bad spark plug.
3. Weak or dead battery.
4. Dirty fuel filter.
5. Stale or dirty fuel.
6. Loose or damaged wiring.
7. Carburetor out of adjustment,
8. Engine valves out of
adjustment.
1. Clean/repiace air filter.
2. Replace spark plug.
3. Recharge or replace battery.
4. Replace fuel filter.
5. Empty fuel tank and refill tank
with fresh, clean gasoline.
6. Check all wiring.
7. See “To Adjust Carburetor”
In Service and Adjustments
section.
8. Contact a Sears or other
qualified service center.
Engine will not
turn over
1. Brake pedal not depressed.
2. Attachment clutch is engaged.
3. Weak or dead battery.
4. Blown fuse.
5. Corroded battery terminals.
6. Loose or damaged wiring.
7. Faulty ignition switch.
8. Faulty solenoid or starter.
9. Faulty operator presence
switch(es).
1. Depress brake pedal.
2. Disengage attachment clutch.
3. Recharge or replace battery.
4. Replace fuse.
5. Clean battery terminals.
6. Check all wiring.
7. Check/replace ignition switch.
8. Check/replace solenoid or
starter,
9. Contact a Sears or other
qualified service center.
Engine clicks but
will not start
1. Weak or dead battery.
2. Corroded battery terminals.
3. Loose or damaged wiring.
4. Faulty solenoid or starter.
1. Recharge or replace battery.
2. Clean battery terminals.
3. Check all wiring.
4. Check/replace solenoid or
starter.
Loss of power 1. Cutting too much grass/too
fast.
2. Throttle in “CHOKE” position.
3. Build-up of grass, leaves and
trash under mower.
4. Dirty air filter.
5. Low oil ievel/dirty oil.
1. Raise cutting height/reduce
speed.
2. Adjust throttle control.
3. Clean underside of mower
housing.
4. Clean/repiace air filter,
5. Check oil level/change oil.
30