V warning: always wear, Assembly – Craftsman 536.886440 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Parts packed separately in carton (not shown full size)
2- Ignition Keys
(Attached to engine in plastic bag)
/V WARNING: Always wear
safety glasses or eye shields
while assembling snow
thrower.
TOOLS REQUIRED FOR
ASSEMBLY
1 - Knife to cut carton
1-1/2 inch wrenches
(or adjustable wrenches)
1-9/16 inch wrenches
(or adjustable wrenches)
1 - 3/4 inch wrenches
(or adjustable wrenches)
1 - Pliers (to spread cotter pin)
1 - Screwdriver
1 - Measuring tape or ruler
Figure 1 shows the snow thrower in the
shipping position.
Figure 2 shows the snow thrower com
pletely assembled.
References to the right or left hand side
of the snow thrower are from the view
point of the operator’s position behind
the unit.
Auger Drive Lever
,
^
-----------Traction
Drive Lever
Shifter
Lever
Clutch Cable
Crank Assembly
Height
Adjust
Skid
Figure 2
TO REMOVE SNOW THROWER
FROM CARTON
1. Locate all parts packed separately
and remove from the carton.
NOTE:
Place fuel stabilizer in a safe
place until needed for storage.