Step 40: (see figure 40) – Craftsman 486.24838 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEP 39: (SEE FIGURE 39)
* Remove the engine pultey keeper from the side of
the tractor frame by removing the washer and nut
that secure the keeper. Attach the new pulley keeper
supplied with the snow thrower, reusing the origina!
bolt, washer and nut.
STEP 40: (SEE FIGURE 40)
• Assembie the short ”V" belt onto the engine pulley
and then onto the large pulley on top of the clutch/idler
assembly. The belt must be placed to the inside of the
engine pulley keeper, the idler pulley and the keeper
bolt located beside the large pulley.
NOTE: Some tractors may already be equipped with a
pulley keeper that is identical to the new one supplied.
IMPORTANT: Do Not assembie the "V" belt around the
outside of the engine pulley keeper or the keeper boit.
Attach the clutch/idler assembly to the tractor frame
as follows. Hook the assembly’s notched arms onto
the two shoulder bolts you assembled to the inside
of the tractor frame. Lift the front of the assembly and
attach it to the R.H, and L.H. hanger brackets using
two pivot lock pins (MM) and 1/S" hairpin cotters (KK),
• Go to step 48 on page 21.
18