Installing router motor, In base (fig. 5, Removing motor from base (see fig. 5) – Craftsman 320.17541 User Manual
Page 17: Asseivibly coni
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEIVIBLY coni
INSTALLING ROUTER MOTOR
IN BASE (Fig. 5}
1. Turn motor off and unplug
from power source.
2. Place fixed base on flat surface.
3. With back of fixed base facing you,
open motor clamp (A)
4.
Press in
Coarse Adjustment
Knob (B)
to depart the
gears (C)
while you align the motor housing's
keystrip (D)
with the
keystrip-slot
(E)
in the fixed base.
5. When the motor's keystrip is
aligned and engaged into the
base's keystrip slot, slide the
motor down into the fixed base.
6. The motor will now slide up or
down to set coarse adjustments
when the coarse adjustment knob
is pressed in.
7. After ail adjustments are made,
close the motor clamp securely.
REMOVING MOTOR FROM BASE (see Fig. 5)
1. Turn motor off and unplug from power source.
2. Place router (fixed base/motor housing) on flat surface.
3.
With back of router facing you, open the
motor damp (A)
4.
Push in
coarse adjustment knob (B)
to release motor housing
“keystrip” (C)
from
gear in base, while you lift motor free of base.
5. Set motor upside down on its top cap with collet pointing up and remove cutter bit
Store motor and base in case when not being used.
/K WARNING:
always
remove cutter bits from collst/nut when the router
is not being used. Leaving bits installed could result in an accident causing
serious personal injury.
17