Storage, Battery, Fuel system – Craftsman 917.25650 User Manual

Page 26: Engine oil, Cylinders, Engine oh, Tractor, Engine, Other

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

STORAGE

Immediately prepare your tractor for storage at the end of

the season or if the tractor will not be used for 30 days or
more.

CAUTION: Never store the tractor with
gasoline in the tank inside a building

where fumes may reach an open flame

or spark. Allow the engine to cool
before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When

mower is to be stored for a period of time, clean it thor­
oughly, remove all dirt, grease, leaves, etc. Store in a

clean, dry area.

« Clean entire tr actor (See “CLEANING” in the Customer

Responsibilities section of this manual).

» Inspect and replace belts, if necessary (See bell re­

placement instructions in the Service and Adjustments

section of this manual).

Lubricate as shown in the Customer Responsibilities

section of this manual

" Be sure that all nuts, bolts and screws are securely

fastened. Inspect moving parts for damage, breakage
and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand

lightly before painting.

BATTERY

Fully charge the battery for storage.

“ After a period of time in storage, battery may require

recharging.

" To help prevent corrosion and power leakage during

long periods of storage, battery cables should be
disconnected and battery cleaned thoroughly (see ‘TO
CLEAN BATTERY AND TERMINALS” in the Cus­

tomer Responsibilities section of this manual).

» After cleaning, leave cables disconnected and place

cables where they cannot come in contact with battery
terminals.

» Be sure battery drain tube is securely attached.

If battery is removed from tractor for storage, do not

store battery directiy on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT:

IT

IS

IMPORTANT

TO

PREVENT

GUM

DEPOSITS

FROM

FORMING

IN

ESSENTIAL

FUEL

SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER,

FUEL

HOSE,

OR

TANK

DURING

STORAGE.

ALSO,

EXPERIENCE

INDICATES

THAT

ALCOHOL

BLENDED

FUELS

(CALLED

GASOHOL

OR

USING

ETHANOL

OR

METHANOL)

CAN

ATTRACT

MOISTURE

WHICH

LEADS

TO

SEPARATION

AND

FORMATION

OF

ACIDS

DURING

STORAGE.

ACIDIC

GAS

CAN

DAMAGE

THE

FUEL

SYSTEM OF AN ENGINE WHILE IN STORAGE.

« Drain the fuel tank.

« Start the engine and let it run until the fuel lines and

carburetor are empty.

» Never use engine or carburetor cleaner products in the

fuel tank or permanent damage may occur.

■ Use fresh fuel next season.

NOTE:

Fuel stabilizer is an acceptable alternative in

minimizing the formation of fuel gum deposits during stor­

age. Add stabilizer to gasoline in fuel tank or storage

container. Always follow the mix ratio found on stabilizer
container. Run engine at least 10 minutes after adding

stabilizer to allow the stabilizer to reach the carburetor. Do

not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine

oil (See “ENGINE" in the Customer Responsibilities
section of this manual).

CYLINDERS

*■ Remove spark plug(s).

■» Pour one ounce of oil through spark plug hole(s) into

cylinder(s).

» Turn ignition key to “START” position for a few seconds

to distribute oil.

® Replace with new spark piug(s).

OTHER

« Do not store gasoline from one season to another.

« Replace your gasoline can if your can starts to rust.

Rust and/or dirt in your gasoline will cause probiems.

" If possible, store your tractor indoors and cover it to

give protection from dust and dirt.

"

Cover you r tractor with a suitable p rotective cover that

does not retain moisture. Do not use plastic. Piastre
cannot breathe which allows condensation to form and
will cause your tractor to rust.

IMPORTANT:

NEVER

COVER

TRACTOR

WHILE

ENGINE

AND EXHAUST AREAS ARE STILL WARM,

26

Advertising
This manual is related to the following products: