Craftsman 486.24608 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEP 3:
(SEE FIGURE 4)
• Place plug on a work bench or solid table and push
end of bumper down onto plug. Repeat for remaining
plugs.
STEP 4:
(SEE FIGURE 5)
•
Remove any bolts present In front mounting holes In
side of tractor frame. If bolt will not screw out of hole,
check If a nut Is present on bolt on Inside of frame.
On GT tractors, If access to nut Is blocked by a front
mounted muffler, slide muffler down exhaust tubes to
rest on top of browning shield.
IMPORTANT: Be sure to re-attach muffler and heat
shield after bumper Is Installed.
•
If rear mounting holes In tractor frame are empty.
Install hex bolts and whiziock nuts supplied In the
parts bags. See figure 5.
Call 1 -866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE