Craftsman 358.794964 - Manual (Page 12)

REPLACE SPARK PLUG
Replace spark plug each year to ensure
the engine starts easier and runs better.
Set spark plug gap at 0.025 inch. Igni­
tion timing is fixed, nonadjustable.
1. Twist, then pull off spark plug boot.
2. Remove spark plug from cylinder
and discard.
3. Replace with Champion CJ-6Y
spark plug and tighten securely
with a 3/4 inch socket wrench.
4. Reinstall the spark plug boot.
REPLACE FUEL FILTER
To replace fuel filter, drain unit by run­
ning it dry of fuel, then remove fuel
cap/retainer assembly from tank. Puil
filter from tank and remove it from the
fuel line. Install new fuel filter on fuel
line; reinstall parts.
CHECK MUFFLER MOUNTING
SCREWS
Once each year, ensure muffler
mounting screws are secure and tight­
ened properly to prevent damage.
Mounting
Screw
Muffler Cover .
Screws
1. Loosen and remove the 2 screws
from the muffler cover.
2. Remove the muffler cover.
3. Tighten the 2 muffler mounting
screws securely.
4. Reinstall muffler cover and 2
screws. Tighten securely.
CARBURETOR ADJUSTMENT
There is no screw for idle adjustment
on your blower. The throttle lever is
used to control engine speed. The
throttle lever can be placed in one of
four positions:
STOP, IDLE or
FULL THROTTLE or ^ , and one inter­
mittent position. If your engine will
not run properly or you require further
assistance, contact your Sears Service
Center or call our customer assistance
help line at 1-800-235-5878.
STORAGE
a WARNING: Perform the following
steps after each use:
• Allow engine to cool, and secure the
unit before storing or transporting.
• Store unit and fuel in a well venti­
lated area where fuel vapors cannot
reach sparks or open flames from
water heaters, electric motors or
switches, furnaces, etc.
• Store unit with all guards in place.
Position unit so that any sharp object
cannot accidentally cause injury.
• Store unit and fuel well out of the
reach of children.
SEASONAL STORAGE
Prepare unit for storage at end of sea­
son or if it will not be used for 30 days
or more.
If your unit is to be stored for a period
of time:
• Clean the entire unit before lengthy
storage.
• Store in a dean dry area.
• Lightly oil external metal surfaces.
FUEL SYSTEM
Empty the fuel system before storage
for 30 days or longer. Drain the gas
tank, start the engine and !et it run until
the fuel lines and carburetor are empty.
Use fresh fuel next season.
Under
FUELING ENGINE in the OPERA­
TION section of this manual, see mes­
sage labeled IMPORTANT regarding the
use of gasohol in your engine.
Fuel stabilizer is an acceptable afterna­
tive in minimizing the formation of fuel
gum deposits during storage. Add stabi­
lizer to gasoline in fuel tank or fuel stor­
age container. Follow the mix instruc­
tions found on stabilizer container. Run
engine at least 3 minutes after adding
stabilizer.
-
12