Assembly & adjustments, Description cont – Craftsman 172.74815 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DESCRIPTION cont.
Cutting Path
12 inches
Speed
7000 RPM
Rating
18.0 Volt
Line Diameter
0.065-inch
twisted
line
Line Feed Mechanism
Automatic
Power Head Tilt
4 positions
Adjust Height of Shaft
From 16 to 25 inches
Charging Stand Input
120V,60Hz AC
Charge Rate
1 hour
Charging Stand Number
CGT183UA-48 (C1817A005)
Battery Pack Number
CGT183UA-42 (WA 3127)
ASSEMBLY & ADJUSTMENTS
CHARGING THE BATTERY PACK (Fig. 3 and 3a)
The battery pack for this tool has been shipped in a low charge condition to prevent
possible problems. Therefore,
you should charge overnight prior to
use.
NOTE: Batteries will not reach full charge the first time they
are
charged. Allow
several cycles (operation followed by recharging) for them to become
fully charged.
1. Charge battery pack only with the charging stand that was supplied with this trimmer.
2. Make sure power supply to the charging stand is normal household voltage, 120 volts,
60 Hz, AC-only.
3. Connect charging stand to power supply.
4. Place battery pack in charging stand. Align raised rib on battery pack with groove in
charging stand (See Page 15, Fig. 3).
5. Press down on battery pack to be sure contacts on battery pack engage properly with
contacts inside charging stand.
14