Craftsman 113.299780 - Manual (Page 8)

assembly
3- Carefully turn the Filtration Housing upside down so
that the Motor endbei! rests against the floor.
4. Support the opposite side of Filtration Housing wlh a
block of wood.
A. Place O -R ing in relief of Inlet pipe {See page 18}
5. Position/n/efGuardinlinewiththethreaded holes on
the base of the Filtration Housing.
NOTE: Make surelnlet Guard is pointing to rear of
machine.
6. Place lockwasher and flat washer on hex screw and
insert through the holes of the Inlet Guard into the
threaded holes of the Filtration Housing as shown.
■ ( / V u : 7 ' ' V v :
' ^ ; A guard must
y ./ . ' 'Í POINT TO
■■ ■■■, It^REAR OF
. V, . MACHINF.
— INLET GUARD
7. Complete the process for the otherthree holes using
same method.
DO NOT SECURE SCREWS AT THIS TIME.
MOUNTING SUPPORT LEGS
1. Locate the following items from the loose parts bag:
Description Qty.
A Flat Washers* {5/16 x 11/16 x 3/32) .....4
B Hex Screws *{M8 x 1.25 - 12).... ..........4
C Lockwashers* {5/16).................. . 4
CAUTION: To avoid injury, keep hands away
from fan blade.
2. Position left Leg Support as shown. .....
3. Place lockwasher and flat washer on hex screw and
insert through the holes in the Support Leg and
secure to the threaded holes in the Filtration Housing
as shown.
4. Use same method to attach Right Support Leg.
5 . Secure hex screws with the use of adjustable wrench.
Items are shown actual size
MOUNTING LEG BRACKET
1. Locate the following items from the loose parts bag:
Description Qty.
A Flat Washers* (5/16 x 11/16 x 3/32).....4
B Hex Screws* (M8x 1.25-12)............ 4
2. Insert Leg Bracket between the Support Legs and
slide against the angled flange of the Leg.
NOTE: Make sure holes in Leg Bracket align with
holes on Leg Support.
3. Place flat washer on hex screw, insert through angled
flange of Leg Support and attach to threaded hole of
Bracket.
4. Repeat steps 2 and 3 using same process on other
three holes.