To assemble your tiller you will need, Operator’s position (see fig. 1), Contents of hardware pack – Craftsman 917.299751 User Manual
Page 6: Assembly, Fibril
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
TO ASSEMBLE YOUR TILLER YOU WILL NEED:
(1) Utility knife
(1) Wire cutter
(1) Screwdriver
(1) Tire pressure gauge
(1) Pair of pliers
(1) 9/16" wrench {or 9/16" socket, ratchet, and extension:
or adjustable wrench)
OPERATOR’S POSITION (See Fig. 1)
The right hand (R.H.) and left hand (L.H.) sides of your tiller
are determined from the operator’s position while standing
behind tiller.
CONTENTS OF HARDWARE PACK
(2) Handle Locks
(2) Carriage Bolts 3/8-16 UNC x 1 Gr. 5
(2) Center Locknuts 3/8-16 UNC
o
------- -
(1) Flat Washer 13/32x 1 x 11 Ga.
Q
(1) Handle Lock Lever
fibril
(2) Hairpin Clips
(1) Cable Clip
î£5iR!iW!Sf<i«ni
(1) Owner's Manual