Assembly, Drawbar a (see figs. 1a,1b&1c), Drawbar b (see fig. id) – Craftsman 917.248980 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
1
BAGGER SUPPORT ASSEMBLY
Determine which type drawbar you have on your tractor.
Compare the drawbar illustrations below to the drawbar
located at the rear of your tractor.
Follow the support assembly instructions that apply to you r
type drawbar.
DRAWBAR A (See Figs. 1A,1B&1C)
Remove and discard the upper bolt on both sides of
the drawbar. Using the same holes, install the shoulder
bolts supplied and tighten securely.
REMOVE AND DISCARD
UPPER BOLTS AND INSTALL
2. Install adapter to both sides of support assembly as
shown.
3.
4.
Align support assembly pin with hole in drawbar and
hang assembly over the shoulder bolts.
Be sure supportassemblyis seated properly and secure
with retainer spring supplied.
SHOULDER
BOLTS
SPRING
FIG. 1C
1
.
2
.
3.
DRAWBAR B (See Fig. ID)
Discard adapters provided - not required for drawbar
type B.
Align support assembly pin with hole in drawbar and
hang assembly over the shoulder bolts.
Be sure supportassemblyis seated properly and secure
with retainer spring supplied.
SHOULDER
BOLTS
SPRING
FIG. ID