Craftsman 486.24839 - Manual (Page 11)

Attach the clutch/idier assembly to the tractor frame
by sliding the notched arms at the rear of the
assembly onto the two shoulder bolts assembled
to the inside of the tractor frame. Lift the front of
the assembly, fitting the sides into the R.H. and
L.H. hanger brackets. Attach the assembly to the
brackets using two pivot lock pins and 1/8" hairpin
cotters. See figure 17.
• Assemble the short "V" belt onto the engine pulley
and then onto the large pulley on top of the clutch/
idler assembly. The belt must be placed to the
inside of the engine pulley keeper, the idler pulley
and the keeper bolt located beside the large pulley.
See figure 18.
IMPORTANT: Do Not assemble the "V" belt
around the outside of the engine pulley keeper or
the keeper bolt.
Hold this drawing above you white viewing the
Ciutch/ldler Assembly from underneath the
tractor. Right and left in the drawing will be the
reverse of the viewer's right and left.
ENGINE
PULLEY
KEEPER
Leñ Side
of Tractor
ENGINE
PULLEY
FIGURE 18 VIEWED FROM UNDERNEATH
• Proceed to page 13.
11