How to start a warm engine, Frozen starter, Operation – Craftsman 536881851 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

OPERATION

felt and then pull rapidly to start the

engine. Do not allow the recoil

starter handle to snap back. Slowly

return the recoil starter handle.

9. If the engine does not start in 5 or 6

tries, See Difficult Starting in the
“Troubleshooting Table”.

10. Allow the engine to warm up for

several minutes. As the engine

warms up, adjust the choke knob
toward the RUN position. Wait until
the engine runs smoothly before

each choke adjustment.

11. (Electric Start) First disconnect

power cord from receptacle. Then,
disconnect the power cord from the
starter motor.

How To Start A Warm Engine

If restarting a warm engine after a short

shutdown, leave the choke lever in the
off position and do not push the primer
button. If the engine fails to start, follow
the Cold Start instructions.

Frozen Starter

If the starter is frozen and will not turn

the engine, follow the steps below.

1. Pull as much starter rope as pos­

sible out of the starter.

2. Release the starter handle and let it

snap back against the starter. Re­
peat until the engine starts.

Warm engines will cause condensation

in cold weather. To prevent possible

freeze-up of recoil starter and engine

controls, proceed as follows after each
snow removal job.

1. With engine off, allow engine to cool

for several minutes.

2. Pull starter rope very slowly until re­

sistance is felt, then stop. Allow the

starter rope to recoil. Repeat three

times.

3. With the engine not running, wipe all

snow and moisture from the carbu­
retor cover in area of controls and
levers. Also, move the choke control

and starter handle several times.

A

WARNING; Never run en­

gine indoors or in enclosed,
poorly ventilated areas. En­

gine exhaust contains CARBON

MONOXIDE, AN ODORLESS AND
DEADLY GAS. Keep hands, feet,
hair and ioose clothing away from
any moving parts on engine and
snow thrower.

• Engine parts, especiaily the muf­

fler, become extremely hot. Se­
vere thermal burns can occur on

contact. Allow the engine to cool

before touching.

• Never allow children to operate

the snow thrower. Never allow

adults to operate the snow throw­
er without proper instruction.

• Keep the area of operation ciear

of ail persons, particularly small
children and pets.

• Never leave the snowthrower un­

attended while the engine is run­
ning. Anyone operating the en­
gine or equipment must carefuily

read and understand the operat­
ing instructions.

16

Advertising