To replace mower blade drive belt (see fig. 24), To adjust brake (see fig. 25), Service and adjustments – Craftsman 917.259592 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 24)
The mower blade drive belt may be replaced without tools.
Park the tractor on level surface. Engage parking brake
BELT REMOVAL -
•
Remove mower from tractor (See ‘TO REMOVE
MOWER" in this section of this manual).
•
Work belt off both mandrel pulleys and idler pulleys.
« Pull belt away from mower.
BELT INSTALLATION -
•
install new belt In reverse order of removal.
•
Make sure belt is in all pulley grooves and Inside all belt
guides.
•
install mower in reverse order of removal instructions.
TO ADJUST BRAKE (See Fig. 25)
Your tractor is equipped with an adjustable brake system
which is mounted on the right side of the transaxte.
if tractor requires more than six (6) feet stopping distance
at high speed in highest gear, then brake must be adjusted.
•
Depress dutch/brake pedal and engage parking brake.
•
Measure distance between brake operating arm and
nut "A" on brake rod.
« if distance is otherthan 1-3/4", loosen jam nut and turn
nut "A" until distance becomes 1-3/4". Retighten jam
nut against nut "A".
® Roadtesttractorforproperstopplngdistanceasstated
above. Readjust if necessary. If stopping distance Is
stilt greater than six (6) feet in highest gear, further
maintenance is necessary. Contact your nearest au
thorized service center..
________
WITH PAftKtNG BRAKE
"ENGAGED"
JAM
NUT
OPERATiNG
ARM
DO NOTTOUCHTHIS NUT. !F FURTHER BRAKE ADJUSTMENT IS
NECESSARY, CONTACT YOUR NEAREST AUTHORIZED SERVICE
CENTER/DEPARTMENT
FIG. 25
23