Craftsman 917.273322 - Manual (Page 30)

TO ADJUST CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be
necessary, check adjustment as de­
scribed below before loosening cable. If
adjustment is necessary, proceed as
follows:
• With engine not running, move choke
control (located on dash panel) to full
choke position.
• Remove air cleaner cover, filter and
cartridge plate to expose carburetor
choke (See “AIR FILTER” in the
Maintenance section of this manual).
• Choke should be closed. If it is not,
loosen casing clamp screw and move
choke cable until choke is completely
closed. Tighten casing clamp screw
securely.
• Reassemble air cleaner.
Closed
Choke
TO ADJUST CARBURETOR
The carburetor has been present at the
factory and adjustment should not be
necessary. However, minor adjustment
may be required to compensate for
differences in fuel, temperature, altitude
or load. If the carburetor does need
adjustment, proceed as follows:
In general, turning the adjusting needles
in (clockwise) decreases the supply of
fuel to the engine giving a leaner fuel/air
mixture. Turning the adjusting needles
out (counterclockwise) increases the
supply of fuel to the engine giving a
richer fuel/air mixture.
IMPORTANT; Damage to the needles
and the seats in carburetor may result if
screw is turned in too tight.
PRELIMINARY SETTING-
* Be sure you have a clean air filter, and
the throttle control cable is adjusted
properly (see “TO ADJUST
THROTTLE CONTROL CABLE" in the
Service and Adjustments section of
this manual).
• With engine off turn idle fuel adjusting
needle in (clockwise) closing it finger
tight and then turn out (counterclock­
wise) 1 turn.
FINAL SETTING-
• Start engine and allow to warm for five
minutes. Make final adjustments with
engine running and shift/motion
control lever in neutral (N) position.
• The high idle is set at the factory and
cannot be adjusted,
• Idle speed setting - With throttle control
lever in slow position, engine should
idle at 1200 RPM. if engine idles too
slow or fast, turn idle speed adjusting
screw in or out until correct idle is
attained,
• idle fuel needle setting - With throttle
control lever in slow position, turn idle
fuel adjusting needle in (clockwise)
until engine speed decreases and
then turn out (counterclockwise)
approximately 3/4 turn to obtain the
best low speed performance.
• Recheck idle speed. Readjust if
necessary.
ACCELERATION TEST-
• Move throttle control lever from slow to
fast position. If engine hesitates or
dies, turn idle fuel adjusting needle
out (counterclockwise) 1/8 turn.
Repeat test and continue to adjust, if
necessary, until engine accelerates
smoothly.
High speed stop is factory adjusted. Do
not adjust-damage may result.
IMPORTANT: Never tamper with the
eninge governor, which is factory set for
proper engine speed. Overspeeding the
engine above the factory high speed
settng can be dangerous. If you think the
engine-governed high speed needs
adjusting, contact your nearest autho­
rized service center/department, which
has proper equipment and experience to
make any necessary adjustments.