Craftsman 486.243222 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

1

Assemble vinyl caps onto the ends of the R.H. and

LH. Hitch Tubes. See figure 1.

Assemble the R.H. Hitch Tube to the spreader frame
tube using two 1/4" x 2" hex bolts and 1/4" nuts. Do

not tighten yet. Repeat for L.H. Hitch Tube. See

figure 1.

Assemble the Hitch Brackets to the Hitch Control
Tube using two 1/4" x 1-3/4" hex bolts and 1/4" nuts.
Tighten. See figure 3.
Assemble the hitch pin through the hitch brackets and
secure with the 1/8" hair cotter pin. See figure 3.

Assemble the Hitch Control Tube between the Hitch
Tubes using two 1/4" x 1-3/4" hex bolts and 1/4" nuts.
Tighten all bolts and nuts . See figure 2.

•

Assemble the vinyl cap onto the Hitch Control Tube.

See figure 4.

•

Assemble the Control Cable to the Hitch Control Tube

using the carriage bolt and nylon wing nut. See figure

4.

Advertising