Installation step 7, Installation step 8, Install the lights – Craftsman 139.53225SRT User Manual

Page 19: Attach the emergency release rope and handle

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

installation Step 7

Imtatt the Light Bttd the Lem

Install the lights

- Install a 75 wait rruiximum light bulb in the scxtket.

The

light

will

turn

ON

and

remain lit for

approximately 4-1/2 minutes when power is
connected. Then the light will turn OFF.

• if the bulb bums out prematurely due to vibration,

replace i! with a standard neck "Garage Door

Opened* * bulb.

install the lens (excepi for Model 53225)

• Apply slight pressure on the sides of the

Ittic,

and

slide the tabs into the slots ¡n the end panel

• Reverse thé procedure to rerriove the lens.

Lem Gyitte

U§nt l*M:

Lew Star

7S W« Ma*.:

Uoht Bulb

Installation Step 8

Attach the Emergency Release

Rope and Handle

. emafgancy

Reieasif Handte

I

Do not use fhe red hanclie to pull the door
open or closed.

The

rope

knot

coald

become

untied and you could fall.

Use the emergency

release only to disengage the trolley and. if
possible, only when the door is closed.

Garage doors are heavy. If the door is open
when

the

handle

is

pulled,

Ihe

door

could

close

inadvertently

if

it

is

not

properly

balanced. Serious injury may result to persons
under the door. Make sure the doorway is clear
of

persons

and

obstructions

before

pulling

handle when door is open.

• Thread one end of the rope through the hole in the

lop of the red handle so •NOTICE’ reads right side
up as shown. Secure with ao overhand knot.

The knot shoyld be at least

1

" from the end of the

rope tO: prevent slipping.

• Thread the other end of the rope through the hole in

the release arm of the outer trolley.

• Adjust rope length so the hanclie is 6 feet above fte

floor. Secure with a.n overhand knot

If it Is necessary to cut the rope, heat seal the cut
end with a match or lighter to prevent unraveling.

13

Advertising
This manual is related to the following products: