Customer responsibilities, Muffler, Spark plug – Craftsman 917.295651 User Manual
Page 15: Transmission, Cleaning, Tiller, To adjust handle height (see fig. 20), To remove wheel (see fig. 21), Service and adjustments
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CUSTOMER RESPONSIBILITIES
MUFFLER
Do not operate tiller without muffler Do not tamper with
exhaust system. Damaged mufflers or spark arresters
could create a fire hazard. Inspect periodically and replace
if necessary, if your engine is equipped with a spark
arrester screen assembly, remove every 50 hours for
cleaning and inspection. Replace if damaged.
SPARK PLUG
Replace spark plugs at the beginning of each tilling season
or after every 50 hours of use, whichevercomesfirst. Spark
plug type and gap setting is shown in “PRODUCT SPECI
FICATIONS” on page 3 of this manuaS
TRANSMISSION
Yourtransmission is sealed and will only require lubrication
if serviced.
CLEANING
® Clean engine, wheels, finish, etc. at ail foreign matter.
» Keep finished surfaces and wheels free of alt gasoline,
oil, etc.
' Protect painted surfaces with automotive type wax.
We do not recommend using a garden hose to clean your
unit unless the muffler, air filter and carburetor are covered
to keepwaterout. Waterin engine can result inashortened
engine life.
SERVICE AND ADJUSTMENTS
A
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come into
contact with plug.
TILLER
TO ADJUST HANDLE HEIGHT (See Fig. 20)
Select handle height best suited for your tilling conditions.
Handle height will be different when tiller digs into soil
» First loosen handle lock lever,
" Handle can be positioned at different settings between
"HIGH" and “LOW” positions,
“ Retighten handle lock lever securely after adjusting.
TO REMOVE WHEEL (See Fig. 21)
» Place blocks under transmission to keep tiller from
tipping,
«
Remove outer side shield by removing nuts “A” and “B".
' Remove inner side shield by removing nuts ”C" and
“
0
”.
» Remove hairpin clip and clevis pin from wheel,
® Remove wheel and tire,
* Repair tire and reassemble.
CAUTION: When mounting tires, un
less beads are seated, overinflation
vi-i can cause an explosion.
« Maintain 20 pounds of tire pressure. If tire pressures
are not equal, tiller will pull to one side.
« Keep tires free of gasoline or oil which can damage
rubber
15