Craftsman 139.53993D - Manual (Page 35)

PROGRAMMING
NOTICE: If this Security4^ garage door opener is operated with a non-rolling code transmitter, the technical measure in
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security+® remote controls.
To Add or Reprogram a Hand-held Remote Control
USING THE “LEARN” BUTTON USING THE PREMIUM CONTROL CONSOLE
1. Press and release the “learn” button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your garage door.
3. Release the button when the motor unit
lights blink. It has learned the code. It
light bulbs are not installed, two clicks
will be heard.
1. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door.
2. While holding the remote button, press
and hold the LIGHT button on the
Premium Control Console.
3. Continue holding both buttons while
you press the push bar on the
Premium Control Console (all three
buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
X
X
To Erase All Codes From Motor Unit
Memory
To deactivate any unwanted remote, tirst erase all codes:
Press and hold the “learn” button on
motor unit until the learn indicator light
goes out (approximately 6 seconds). All
previous codes are now erased.
Reprogram each remote or keyless entry
you wish to use.
35
*3-Function Remotes
If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons on
any Security+® 3-Function
remote or compact remote
can be programmed to
operate other Security+®
garage door openers.