Storage – Craftsman 358.795800 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

a WARNING:

Recheck the idle

speed after each adjustment. The

trimmer head or blade must not move

or spin at idle speed to avoid serious
injury to the operator or others.

Idle Speed

Screw

If you require further assistance or are

unsure about performing this proce­

dure, contact your Sears Service Cen­

ter or call our customer assistance

help line at 1 -800-235-5878.

STORAGE

a WARNING:

Perform the follow­

ing steps after each use:
• Allow engine to cool before storing

or transporting.

• Store unit and fuel in a well venti­

lated area where fuel vapors cannot
reach sparks or open flames from

water heaters, electric motors or
switches, furnaces, etc.

• Store unit with all guards in place.

Position unit so that any sharp ob­

ject cannot accidentally cause injury.

• Store unit and fuel well out of the

reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of sea­
son or if it will not be used for 30 days
or more.
If your unit is to be stored for a period
of time:
• Clean the entire unit before lengthy

storage.

• Store in a clean dry area.
• Lightly oil external metal surfaces.

FUEL SYSTEM

Empty the fuel system before storage

for 30 days or longer. Drain the gas
tank, start the engine and let it run un­
til the fuel lines and carburetor are

empty. Use fresh fuel next season.
Under

FUELING ENGINE

in the

OPERA­

TION

section of this manual, see mes­

sage labeled

IMPORTANT

regarding

the use of gasohol in your engine.

Fuel stabilizer is an acceptable alter­
native in minimizing the formation of

fuel gum deposits during storage. Add

stabilizer to the gasoline in the fuel

tank or fuel storage container. Follow
the mix instructions found on stabilizer

container. Run engine at least 5 min­

utes after adding stabilizer.

Craftsman 40:1,2-cycle engine oil {air
cooled) is already blended with fuel
stabilizer. If you do not use this Sears
oil, you can add a fuel stabilizer to
your fuel tank.

ENGINE

• Remove spark plug and pour 1 tea­

spoon of 40:1, 2-cycle engine oil (air
cooled) through the spark plug
opening. Slowly pul! the starter rope
8 to 10 times to distribute oil.

• Replace spark plug with new one of

recommended type and heat range.

• Clean air filter.
• Check entire unit for loose screws,

nuts, and bolts. Replace any dam­

aged, broken, or worn parts.

• At the beginning of the next season,

use only fresh fuel having the proper

gasoline to oil ratio.

OTHER

• Do not store gasoline from one sea­

son to another.

• Replace your gasoline can if it starts

to rust.

16

Advertising