Craftsman 900.370520 - Manual (Page 6)

To Unfold Handle
Raise the handle section into place and
secure by tightening the two knobs. See
figure below.
WARNING: For your own safety DO NOT
use this mower without either the
Grasscatcher or Mulch Insert in operating
position.
QRASSCATCHER ASSEMBLY
• Slide the grassbag onto the grasscatcher
frame. (See Fig. A)
• The grassbag has attachment dips sewn
around the bag opening.
• Attach the two top clips to the frame,
then attach the side clips, and lastly the
bottom dip. (See Fig. B)
• Refer to “To Install Grasscatcher” instruc­
tion before attaching to mower.
TO INSTALL GRASSCATCHER
• Reach down between the mower handle
and raise the rear door to a vertical posi­
tion. (See Fig. A)
• Remove the mulch insert. See page 12
“To Remove Mulch Insert”,
• Pick up the grasscatcher by the handle
and lower the grasscatcher between the
lawnmower handles. Position the grass­
catcher hanger hooks on the metal rod
under the rear door. (See Fig. B).
• Release the rear door.
WARNING: Never operate the mower
unless the hanger hooks on the grass­
catcher are seated properly, and the rear
discharge door rests firmly against the top
of the grasscatcher.