Tractor, Battery, Engine – Craftsman 917.271130 User Manual

Page 27: Storage

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

STORAGE

Immediately prepare your tractor for

storage at the end of the season or if the

tractor will not be used for 30 days or

more.

^ CAUTION: Never store the tractor

with gasoline in the tank inside a

building where fumes may reach an

open flame or spark. Allow the engine to

cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter

storage. When mower is to be stored for

a period of time, clean it thoroughly,

remove all dirt, grease, leaves, etc. Store

in a clean, dry area.

• Clean entire tractor (See “CLEANING”

in the Maintenance section of this

manual).

• Inspect and replace belts, if necessary

(See belt replacement instructions in

the Service and Adjustments section of

this manual).

• Lubricate as shown in the Mainte­

nance section of this manual.

• Be sure that all nuts, bolts and screws

are securely fastened. Inspect moving
parts for damage, breakage and wear.

Replace if necessary.

• Touch up all rusted or chipped paint

surfaces; sand lightly before painting.

BATTERY

• Fully charge the battery for storage.
• After a period of time in storage,

battery may require recharging.

• To help prevent corrosion and power

leakage during long periods of
storage, battery cables should be
disconnected and battery cleaned

thoroughly (see “TO CLEAN BATTERY

AND TERMINALS” in the Maintenance

section of this manual).

• After cleaning, leave cables discon­

nected and place cables where they

cannot come in contact with battery

terminals.

• If battery is removed from tractor for

storage, do not store battery directly on
concrete or damp surfaces.

ENGINE
FUELSYSTEM

IMPORTANT: It is important to prevent

gum deposits from forming in essential

fuel system parts such as carburetor, fui

filter, fuel hose, or tank during storage.

ethanol or methanol) can attract moisture

which leads to separation and formation

of acids during storage. Acidic gas can

damage the fuel system of an engine

while in storage.
• Drain the fuel tank.
• Start the engine and let it run until the

fuel lines and carburetor are empty.

• Never use engine or carburetor

cleaner products in the fuel tank or
permanent damage may occur.

• Use fresh fuel next season.

NOTE:

Fuel stabilizer is an acceptable

alternative in minimizing the formation of

fuel gum deposits during storage. Add

stabilizer to gasoline in fuel tank or
storage container. Always follow the mix
ratio found on stabilizer container. Run
engine at least 10 minutes after adding

stabilizer to allow the stabilizer to reach
the carburetor. Do not drain the gas tank

and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace

with clean engine oil. (See “ENGINE" in
the Maintenance section of this manual).

CYLINDER(S)

• Remove spark plug(s).
• Pour one ounce of oil through spark

plug hole(s) into cylinder(s).

• Turn ignition key to “START” position

for a few seconds to distribute oil.

• Replace with new spark plug(s).

OTHER

• Do not store gasoline from one season

to another.

• Replace your gasoline can if your can

starts to rust. Rust and/or dirt in your
gasoline will cause problems.

• If possible, store your tractor indoors

and cover it to give protection from
dust and dirt.

• Cover your tractor with a suitable

protective cover that does not retain

moisture. Do not use plastic. Plastic

cannot breathe which allows conden­
sation to form and will cause your
tractor to rust.

IMPORTANT

: Never cover tractor while

engine and exhaust areas are still

warm.

Also, experience indicates that alcohol

blended fuels 9called gasohol or using

27

Advertising