Canon i 860 - Manual (Page 3)

and the other empty. There’s a transit space between the
two spaces for the ink to move from the empty space (a
reservoir) to the foam filled space. The computer uses
infra red technology to read the tanks and can report the
amount of ink remaining to you using the software “setup
utility). Another nice feature is the fact that the tanks are
clear plastic, so you can find out how low the ink is just by
taking out the tanks and looking at them.
Important : Don’t confuse the two black tanks! The large
tank “BK3e” is pigmented ink. It’s used primarily for text.
The smaller black tank “BK6” is dye based and is used for
photo. Don’t put pigmented ink into the small tank--it won’t
work! You may wind up buying a new cartridge!!!
HERE WE GO!!!
First, have the syringe laying down in front of you already
filled with the ink of choice, your rubber gloves on, paper
down on the table, and a sink nearby. You’ll need to
carefully clean the syringe after each fill in order to prevent
cross contamination. Have the drill handy to pick up with
the drill inserted. Have the glue gun hot and ready to go.
METHOD
You’ll need to drill two holes, one in each of these spaces,
on the
top of each. Drill the first above the foam filled area
and slightly down into the foam to be sure there’s a clear