Craftsman 315.11196 - Manual (Page 9)

OPERATION
TO INSTALL BATTERY PACK
■ Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 3.
■ Place battery pack in your drill. Align raised rib
inside drill with groove on battery pack. See
Figure 4.
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK Fig. 4
■ Make sure the latches on each side of your
battery pack snap in place and battery pack is
secured in drill before beginning operation.
^ CAUTION: When placing battery pack in your
. drill, be sure raised rib inside drili aligns with
groove on battery pack and latches snap in place
properly. Improper assembly of battery pack can
cause damage to interna! components.
TO REMOVE BATTERY PACK
■ Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 3.
■ Locate latches on end of battery pack and
depress to release battery pack from your drill.
See Figure 4.
■ Remove battery pack from your drill.
KEYLESS CHUCK
See Figure 5.
Your new drill has a keyless chuck. As the name implies,
you can hand tighten or release drill bits in the chuck
jaws. Grasp and hold the collar of the chuck with one
hand. Rotate the chuck body with your other heuKi. The
arrows on the chuck indicate which direction to rotate
the chuck body in order to LOCK (tighten) or UNLOCK
(release) the drill bit.
UNLOCK
(RELEASE)
CHUCK
COLLAR
DRILL BIT
LOCK
(TIGHTEN)
CHUCK
BODY
Fig. 5
WARNING: Do not hold chuck body with one
hand and use power of the drill to tighten chuck
jaws on drill bits. Chuck body could slip in your
hand or your hand could slip and come in contact
with rotating drill bit. This could cause an
accident resulting in serious personal injury.