Craftsman 137.219100 - Manual (Page 19)

FGSlTIONiNG THE TABLE AND WORKPIECE
(FIGURE ÄÄ and BB)
1. Lock the table (1} to the column (2) at a position so
the tip of the drill bit (3) is just above the top of the
workpiece (4).
2. A lways place a back - up material (scrap wood)
on the table beneath the workpiece. This will prevent
splintering or heavy burring on the underside of the
workpiece. To keep the back-up material from spinning
out of control, it MUST contact the LEFT side of the
column.
A WARNING
To prevent the workpiece or backup material from being
torn from your hands while drilling, you MUST position it
against the left side of the coiumn. if the workpiece or
the backup materia! is not long enough to reach the
column use the fence provided with the drill press to
brace the workpiece, or clamp it to the table. Failure to
do this could result in personal injury.
3. For small pieces that cannot be clamped to the table,
use a drill press vise (optional accessory).
The drill press vise MUST be damped or boited to the
table to avoid injury from a spinning workpiece, or
damaged vise or bit parts.
Remove the drill press fence when it interferes with other
drill press accessories.
Fig. BB
HOLDING A DRILLING LOCATION
1. Using a centerpunch or sharp nail, make an
. indentation in the workpiece where you want the hole.
2. Using the feed handles, bring the drill down to align
with the indentation before turning the drill “ON”.
TILTING THE TABLE (FIGURE CC)
NOTE: The table and support (1) has a predrilled hole
with a locking pin inserted for locking the table into a
predetermined 0° horizontal position.
1, To use the table in a bevel (tilted) position, TIGHTEN
the nut (2) on the locking pin clockwise to RELEASE
it from the table support.
2. Loosen the large hex head bevel locking bolt (3).
ik WARNING
io prevent injury, be sure to hold the table & table arm
assembly, so it will not swivel or tilt.
Fig. CC
3.
4.
5.
Tilt the table, aligning the desired angle measurement
to the zero line opposite the scale (4). Tighten the bevel
locking bolt.
To return the table to its original position, loosen the
bevel locking bolt (3). Realign the bevel scale (4) to
the 0° position.
Loosen the nut (2) on the locking pin to the OUTSIDE
END OF THREADS. Gently tap the locking pin until it
is seated in the hole. Finger tighten the nut.
To avoid injury from spinning work or tool breakage, always
damp workpiece and backup material securely to the
table before operating the drill press with the table tilted.
FEEDING
1. Pull down the feed handles with only enough effort to
allow the drill bit to cut.
2. Feeding too slowly might cause the drill bit to burn.
Feeding too rapidly might stop the motor, cause the
belt or drill to slip, or tear the workpiece loose and
break the drill bit.
3. When drilling metal, it may be necessary to lubricate
the drill bit tip with motor oil, to prevent burning the tip.
19