Attaching grass catcher, Grass catcher chute, Removing grass catcher – Craftsman 247.270250 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Thumb Screw
Rat Washer
Deck
Mulch Plug
Figure 3
NOTE:
The grass bag must be in positior), on the
vehicle, for any kind of mowing operation, including
mulching and side-discharge of grass clippings.
Attaching Grass Catcher
The grass catcher is assembled at the factory and
attached to the vehicle for shipping convenience. The
grass catcher has to be attached to the vehicle only
when cutting grass and/or bagging the grass clippings.
If the grass catcher was removed from the unit for some
reason, re-attach by following instructions below.
1. Hold the grass catcher by the two handles and slide
it on top of the utility bed at the back of the vehicle.
Make sure that the side of the grass catcher with
the opening is aiigned with the vehicle frame
behind the seat.
2. Pull the two retainer straps on two sides of the
grass catcher and attach loose ends of №e strap to
the respective hook on the frame of the vehicle.
See Figure 4.
NOTE:
The bag switch will automatically shut off
the
engine if the grass catcher is not attached to
/he
unit
while cutting grass. Do not remove the bag even when
using the mulch plug or the side-discharge chute.
Grass Catcher Chute
1. Piace the cutting deck in the lowest position by
sliding the deck lift lever to the appropriate slot.
Slide the elbow of the grass catcher chute through
the vehicle frame and align the chute opening with
the corresponding opening on the vehicle frame.
See Figure 5.
2
.
3.
4.
5.
Align the two holes on the other end of the chute
with the two comesponding holes on the deck. See
Figure 6.
Insert thumb screw and flat washer, removed
earlier, through the left hole on the grass catcher
chute and corresponding hole on the deck. Thread
the screw a few turns to secure, but do not tighten.
See Figure 6.
Repeat on the right side. Tighten both screws.
Thumb
Figure 6
Removing Grass Catcher
1. Unhook frie two retainer straps securing the grass
catcher to the frame of the vehicle.
2. Holding the grass catcher firmly by the handle, slide
it slightly upward and outward to remove.